[wpdreams_ajaxsearchpro id=1]
KFOB Parameter Configuration in RazBerry, Fibaro & Co.
7. August 2015
0
keyfob

Configuring devices

For the Razberry:

Got to the expert UI and select your device in the ‘Configuration’ tab and then the ‘Expert Commands’. Scroll down to ‘Configuration’ and enter the parameter plus the value you want to set. If you are unsure about which parameters you should set please refer to the device’s manual.

keyfob-razberry

Click on ‘Set’ and the controller will set the value after you wake up your device the next time.

To associate devices with groups you can go the ‘Association’ tab and click on the plus on the right. After you select a device in the drop down menu it will be associated with the group.

keyfob-razberry2

For the Hauppauge/Zippato Box:

Go to the device manager after you finished including your device. In the Zwave Network you should see your new device. Click on the little cogwheel and you get to the configuration of the device.

keyfob-zipato

In the ‘Configuration’ tab you can add new parameters. You can read all about the devices parameters and their values in the device’s manual.

keyfob-zipato2

For the Home Center:

Select your device and go to the ‘Advanced’ tab. Here you scroll to the bottom and add all the parameters you want as shown in the example below. You can read all about your device’s parameters and their values in it’s manual.

keyfob-fibaro

For the Vera:

Select your device and go to its ‘Device Options’. Here you can ‘Add configuration settings’ and give them the number of the parameter plus the ‘Desired Value’. To see what parameters you should set please refer to the device’s manual. When everything is set you can save the changes.

vera-keyfob


Leave a reply

Your email address will not be published. Required fields are marked *